周小新, 胡小键. 超高效液相色谱串联质谱法测定饮用水中双酚S、双酚F和双酚A[J]. 环境卫生学杂志, 2020, 10(2): 196-200. DOI: 10.13421/j.cnki.hjwsxzz.2020.02.020
    引用本文: 周小新, 胡小键. 超高效液相色谱串联质谱法测定饮用水中双酚S、双酚F和双酚A[J]. 环境卫生学杂志, 2020, 10(2): 196-200. DOI: 10.13421/j.cnki.hjwsxzz.2020.02.020
    ZHOU Xiaoxin, HU Xiaojian. Direct Determination of Bisphenol S, Bisphenol F, and Bisphenol A in Drinking Water by Ultra-performance Liquid Chromatography-Mass Spectrometry[J]. Journal of Environmental Hygiene, 2020, 10(2): 196-200. DOI: 10.13421/j.cnki.hjwsxzz.2020.02.020
    Citation: ZHOU Xiaoxin, HU Xiaojian. Direct Determination of Bisphenol S, Bisphenol F, and Bisphenol A in Drinking Water by Ultra-performance Liquid Chromatography-Mass Spectrometry[J]. Journal of Environmental Hygiene, 2020, 10(2): 196-200. DOI: 10.13421/j.cnki.hjwsxzz.2020.02.020

    超高效液相色谱串联质谱法测定饮用水中双酚S、双酚F和双酚A

    Direct Determination of Bisphenol S, Bisphenol F, and Bisphenol A in Drinking Water by Ultra-performance Liquid Chromatography-Mass Spectrometry

    • 摘要:
      目的 建立饮用水中双酚S(BPS)、双酚F(BPF)和双酚A(BPA)的超高效液相色谱—串联质谱(UPLC-MS/MS)直接测定方法。
      方法 以甲醇—水为流动相梯度洗脱,水样经Waters ACQUITY UPLC©HSS T3色谱柱分离,采用负离子电喷雾多反应监测模式进行检测,外标法定量。
      结果 UPLC-MS/MS色谱分离良好,BPS、BPF和BPA在(0.5~50.0)μg/L浓度范围内线性相关系数均大于0.997,BPS、BPF和BPA的方法检出限分别为0.002、0.05和0.15 μg/L,加标回收率范围为90.1%~108%,相对标准偏差(RSD)为0.57%~5.90%。
      结论 UPLC-MS/MS操作简便、分析速度快、灵敏度高,适用于饮用水中双酚类化合物的测定。

       

      Abstract:
      Objective To establish an ultra-performance liquid chromatography-mass spectrometry method for direct determination of bisphenol S (BPS), bisphenol F (BPF), and bisphenol A (BPA) in drinking water.
      Methods With a mobile phase of methanol-water for gradient elution, the water samples were separated on a Waters Acquity UPLC-HSS T3 column (2.1 mm×100 nm, 1.8 μm) and were then detected by electrospray ionization mass spectrometry in multi-reaction monitoring mode, and the external standard method was used for quantification.
      Results This method had good chromatographic separation, and BPS, BPF, and BPA had a linear correlation coefficient of >0.997 within the range of(0.05~50.0) μg/L. The method detection limits of BPS, BPF, and BPA were 0.002, 0.05, and 0.15 μg/L, respectively, and the recovery of standard addition ranged from 90.1% to 108%, with relative standard deviations of 0.57%~5.90%.
      Conclusion The method is simple, rapid, and sensitive and can be used for determining bisphenol compounds in drinking water.

       

    /

    返回文章
    返回